英文字典,中文字典,查询,解释,review.php


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       


安装中文字典英文字典辞典工具!

安装中文字典英文字典辞典工具!










  • ADC Causing PIC to Hang? Possible? - Microchip Technology
    When I power on the PIC, it runs through the main loop a few times and then hangs Reset it and it runs a few more times and then quits Reset it again and it runs through the main loop once and dies The number of times through the loop is inconsistent, but the hangs are almost certain
  • PIC 16LF1829 reset itself during the adc-measure - Stack Overflow
    Since one week I have the problem, that my PIC 16LF1829 does itself reset, when he's measuring the selected adc channel I talked to several co-workers, but none could me help by that I tried to change the adc-frequency, changed the voltage reference and the selected channel
  • What could cause a microcontroller to unexpectedly reset?
    On PIC and dsPIC chips, I have observed the following causes of unexpected reset Reset pin driven low or floating Check the obvious stuff first! ESD coupling into the reset pin I've seen this happen when completely unrelated equipment gets turned on on the same desk
  • Pic18F14k50 - ADC causing pic to hang? Possible?
    When this occurs, the ADC Interrupt Flag (ADIF) does not get set, the ADGO DONE bit does not get cleared, and the conversion result does not get loaded into the ADRESH and ADRESL result registers Problem solved
  • PIC12 - ADC never returning zero - Page 1 - EEVblog
    But when I turn the pot completely down, I only get 44 from the ADC while the voltage on the ADC pin is around 0 1mV according to my (cheap) multimeter Directly connecting the ADC pin to GND or using a different PIC12F1572 did not make a difference; the ADC still did not go lower as 44
  • PIC 18F4520 resets itself and keeps in reset when any voltage greater . . .
    When I apply 5V on AN1 and AN2 it doesn't bother the PIC uC but when anything greater than 3V to the AN0, Pic resets itself and kept at reset till voltage goes under 3V Does anyone else encountered with such problem?
  • SOLVED - PIC seems to RESET unless I add a PAUSE in Mainloop
    During normal operation, a WDT time-out generates a device RESET If the device is in SLEEP mode, a WDT time-out causes the device to wake-up and continue with normal operation, this is known as a WDT wake-up The WDT can be permanently disabled by clearing the WDTE configuration bit
  • ADC Activation causing dsPIC reset - Microchip Technology
    I have just tried CE401_ADC_1MBS as listed on the dsPIC33EP512MU810 device page Compiling it and stepping through the ADC method (in the disassembly listing) it still resets when I step on the AD On instruction Actually, now the symptom is that is says ' Stepping target failed'


















中文字典-英文字典  2005-2009