英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字,中文词皆可:

NEC    音标拼音: [n'ɛk]
日本电气公司 ; 网内会议信件协调人,( NET ECHOMAIL
COORDINATOR 的缩写。负责协调网内有关echomail事务)

日本电气公司 ; 网内会议信件协调人,( NET ECHOMAIL COORDINATOR 的缩写。负责协调网内有关echomail事务)



安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • NEC Requirements for Generators and Standby Power Systems
    Mike Holt Enterprises, Inc • www MikeHolt com • 888 NEC CODE (632 2633) 5 NEC Requirements for Generators and Standby Power Systems 445 18 Disconnecting Means Generators must have one or more disconnecting means that disconnects all power, except where: Figure 445–7 (1) The driving means for the generator can be readily shut down, and
  • Is there a Resistivity of Conductors (K) chart in the NEC?
    The K factor isn't specifically stated in the NEC, but wire sizes and their circular mils and resistance are Using these, you can derive it from the tables in the NEC For example, Chapter 9, Table 8 says that 1000 kcmil uncoated copper at 75 degrees has a resistance of 0 0129 ohms kft, suggesting that a conductor of 1 circular mil 1000 ft
  • 80% rule? - Electrician Talk
    80% rule applies to continious loads such as motors, lighting or any load expected to be on 3 hours or more A breaker is rated for 100% of the noncontinious load which may include outlets or other small appliance
  • Continuous Load: what is maximum current - Electrician Talk
    From the 2023 NEC Article 100 Definition: Continuous Load: A load where the maximum current is expected to continue for 3 hours or more 210 20(A) Continuous and Noncontinuous Loads "Where a branch circuit supplies continuous loads or any combination of continuous and noncontinuous loads
  • NECA Workmanship standard, installment 1 | Electrician Talk
    In the 2005 NEC, a fine print note (FPN) was added to give reference to a NECA ANSI standard that defines such workmanship The FPN reads: FPN: Accepted industry practices are described in ANSI NECA 1-2000, "Standard Practices for Good Workmanship in Electrical Contracting", and other ANSI-approved installation standards
  • Nipple conduit fill - Electrician Talk
    In the NEC there is a rule that the conduit fill percentage can be up to 60% for nipples 24" or shorter In the CEC, I'm not aware of any relaxation on the normal raceway fill allowances, regardless of length Just wanting to double check
  • 2023 NEC Work surfaces vs Countertop surfaces. - Electrician Talk
    2023 NEC Work surfaces vs Countertop surfaces Jump to Latest 3 5K views 2 replies 2 participants last post by backstay Apr 24, 2023
  • NEC 408. 4 requirement - Electrician Talk
    I am new to this forum I am an electrician working in Massachusetts I've dealt with various inspectors interpreting NEC 408 4 - "every circuit and circuit modification must be legibly identified with a clear and specific purpose or use, including sufficient detail to distinguish each circuit, " different ways
  • Understanding Table 220-55 - Electrician Talk
    The NEC does not define ranges, ovens or cooktops but based on manufacturers usage a range is a unit that has a cooktop and oven built together in one appliance An oven is just a single or double appliance for baking , roasting, etc A cooktop is just the burners without the oven
  • EMT Fittings for Damp Locations. | Electrician Talk
    NEC 358 42 Couplings and Connectors Couplings and connectors used with EMT shall be made up tight Where buried in masonry or concrete, they shall be concretetight type Where installed in wet locations, they shall comply with 314 15 No mention of "damp"





中文字典-英文字典  2005-2009