英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字，中文词皆可：

undeformed    

安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • SA 2D Connections - United States Army
    The SA 2D Connections layer is used for connections between storage areas and 2D flow areas It is also used as a hydraulic connection within a 2D Flow Area A hydraulic structure used within a
  • SA 2D Connection Data Command - CivilGEO Knowledge Base
    To establish a hydraulic connection between two storage areas, 2D flow areas, or inside a 2D flow area, the SA 2D Connection Data dialog box will be used Follow the steps below to use the SA 2D Connection Data command:
  • Transect for Extracting Flow in a 2D Area - Kleinschmidt
    HEC-RAS 5 0 does not have a specific tool for extracting flow data along a line in a 2D area, however it CAN be done Here’s how you do it Inside your 2D area, draw a 2D Area Connection where you would like to extract flow
  • Help With HEC RAS ERROR - Kleinschmidt
    The SA 2D connection has a culvert lower than the cell it is connected to I measured the culverrt inverts off the GIS contours and they are correct The only way to solve the problem is to have the culvert be ‘floating in air’ and flush with the top of roadway
  • Storage Area and 2D Flow Area Connections - United States Army
    Storage Area 2D Flow Area connections (SA 2D Area Conn) are used to link two storage areas together with a hydraulic structure, or two 2D Flow Areas, or a storage area to a 2D Flow Area
  • Modeling Reservoir and Dam in 2D HEC-RAS by Storage Area and SA 2D . . .
    Instead of being modeled in 1D HEC-RAS by storage area and inline structure, reservoir and dam can also be modeled in 2D HEC-RAS by storage area + SA 2D connection + downstream area in 2D domain (Figure 1)
  • Rating Curves Part 3: 2D models - Surface Water
    Extracting a Rating Curve from SA 2D Area Connection Line in the Geometry Editor A connection line is one of the simplest ways to generate a rating curve from a 2D model To do this, you would delineate a SA 2D Area Connection as shown below, and enforce the connection as a breakline
  • SA 2D Connection problem - Kleinschmidt
    To fix this problem, you need to either: Swap the ‘From’ and ‘To’ connected storage area (2d flow area) names Reverse the centerline stationing (and likely the weir profile data as well) The model was built according to all the rules, in the connection parameters the correct flow direction is indicated from where to
  • Bridges in 2D Areas-Important Update! | Kleinschmidt
    Use a SA 2D Area Connection with a gate (or gates) This is particularly useful for narrower bridges with relatively large openings when the bridge deck is impacted by the flood If the bridge has piers, you can use multiple gates, the spacing between them used to simulate the piers
  • Hydraulic Structures Inside of 2D Flow Areas - United States Army
    The SA 2D Hydraulic Connection can be used to model all kinds of structures inside of a 2D Flow Area Flow going over top of the structure can be modeled with either a weir equation, or





中文字典-英文字典  2005-2009