英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字,中文词皆可:

perpetrate    音标拼音: [p'ɚpətr,et]
vt. 做(恶),犯(罪),胡说

做(恶),犯(罪),胡说

perpetrate
v 1: perform an act, usually with a negative connotation;
"perpetrate a crime"; "pull a bank robbery" [synonym:
{perpetrate}, {commit}, {pull}]

Perpetrate \Per"pe*trate\, v. t. [imp. & p. p. {Perpetrated}; p.
pr. & vb. n. {Perpetrating}.] [L. perpetratus, p. p. of
perpetrare to effect, perpetrare; per patrare to perform.]
To do or perform; to carry through; to execute, commonly in a
bad sense; to commit (as a crime, an offense); to be guilty
of; as, to perpetrate a foul deed.
[1913 Webster]

What the worst perpetrate, or best endure. --Young.
[1913 Webster]



安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • Briggs popping - Lawn Mower Forum
    So here’s the deal 2019 Briggs 33R777 0012 G1 fires right up every time Runs rough and pops at high rpm (although it won’t get nearly as high as it should) but runs smooth at low RPM I’ve both cleaned the OEM carb and replaced the carb, same issue Valve clearance is good on intake exhaust Fuel is fresh Flywheel key is in place
  • B S compatibility (parts swapping) | Lawn Mower Forum
    Briggs engines are in series or families with the same capacity Small Hp differences are done with carbs , big differences are done with bore stroke The easiest way to see if the heads SHOULD interchange is to check the part number of the head gaskets for each engine If it is the same the heads should interchange
  • Briggs Ignition - Weak Spark | Lawn Mower Forum
    And Briggs does not publish any specs for testing these Magnetrons other than they must be able to jump a 1 66" air gap using their testers I do however know the latest Magnetrons test around 6 K ohms on the secondary to coil metal frame and the kill tab to metal frame 1 5-1 7 ohms but this does not test the trigger circuitry
  • Intek v-twin valve adjustment procedures | Lawn Mower Forum
    What valve adjustment procedures do you use on Briggs Intek V-twins? I'm aware of the factory procedure (setting each cylinder at 1 4" off TDC), but I'm curious to know how many are actually doing this versus setting them at TDC or setting one valve when the other is all the way open
  • Briggs - Gas Blowing Out of Carb | Lawn Mower Forum
    Briggs Engine 127802-0640-01 95091859 Carb has primer bulb Toro Push Mower Problem-Symptoms: 1 Engine starts and runs great for a few minutes and then runs "rough" for 15-20 seconds and then runs smooth for another minute or so and then runs rough again 2 After troubleshooting, I noticed
  • Briggs 17. 5 PROPER valve Adjustment method Debate
    On a Briggs engine 0 004" is near the maximum for the inlet minimum for the exhaust So to make it easier for those who have no idea about why they are setting the valve lash or are just plain lazy, a lot of techs will use 0 004" on both
  • B S 19. 5 compression camshaft issue | Lawn Mower Forum
    All of the 210000, 280000, 310000, and 330000 series OHV engines use the same camshaft but for some reason the 310000 and 330000 are the engines that these are constantly failing on Now take that with a grain of salt as these are also the most installed Briggs single cylinder rider engines so the volume of them out there is huge
  • Runs but doesnt rev up - Lawn Mower Forum
    Hello again, i'm not sure if this is a problem from my other posts but i got my briggs and stratton mower running after a year or being stored in the shed I prime the carb 3 times as instructed and the mower starts as it should but its not reving up as it should It idles very low but it
  • Engine locks up and wont turn over (crank) | Lawn Mower Forum
    The engine is an 18 HP Briggs Vanguard It has a new battery and solenoid but the starter is original Any
  • How to swap choke-a-matic over to manual choke - Lawn Mower Forum
    I have a Briggs Stratton 20hp Vtwin Intek engine, model 406777 Type 0442 I recently replaced the carburetor with part#791230, manual choke Unbeknownst to me, the old carburetor was a choke-a-matic and should have been replaced with part#796258





中文字典-英文字典  2005-2009